One 5/8" mounting hole
We utilize a CNC laser cutting table for the cutting of all our AR500 products.
Plasma cutting cuts slowly, this puts a lot of heat into the steel. ( Submerged plasma cutting machine is no better) This excess heat can result in excessive chipping and damage near the cut edge during use and easily shattering when shot. Plasma cutting generates large amounts of heat that is deposited into the target, softening its edges. The heat-affected zone (HAZ) generated by plasma cutting is the largest out of the most commonly used methods for cutting abrasion resistant steel. Most AR500 is cut with plasma cutters as they are cheap and relatively small compared to other methods.
Superior Material : AR500 steel with 477 - 550 BHN Minimum surface hardness of 477 BHN. Core hardness 450 min BHN
3/8" AR500 steel targets work great for the following calibers 223, 5.56, 5.45×39, 7.62×39 and 308. For velocities over 3000fps MV use at 200 yards minimum. 1/4" AR500 is for Handguns and should be used no closer than 10 yards and rifles 100 yards. Be sure you have a downward angle to direct splatter away from shooter towards the ground.
All targets are raw and unfinished
All of our AR500 targets carry a limited lifetime guarantee from breakage
Size: 7"x 12" mini IDPA target Package Contents: One 7" x 12" AR500 steel Target